The DS1100 is a compact BASIC-programmable controller targeting cost-sensitive serial-over-IP and serial control applications.
Built around the same T2000 ASIC as our EM500 "MiniMo" module, the DS1100 offers a single-channel RS232 port. Device power can be supplied via its power jack, pin9 of the DB9 (serial port) connector, or the optional power-over-Ethernet board.
There are three LEDs on the device's front: green and red main status LEDs, and a yellow Ethernet link LED.
Each DS1100 is supplied with the DIN rail and wall mounting plates.
The device comes preloaded with a fully functional serial-over-IP application.
Specifications:
• Superior upgrade to the DS203 device.
• Based on the second-generation ASIC (T2000).
• 10/100BaseT auto-MDIX Ethernet port.
• Optional power-over-Ethernet.
• Single-channel RS232 port on DB9M connector:
• TX, RX, RTS, CTS, DTR, and DSR lines;
• Baudrates of up to 115200bps;
• None/even/odd/mark/space parity modes;
• 7/8 bits/character modes;
• Optional RTS/CTS flow control;
• "12V" power input on pin 9 of the DB9.
• 512KB flash memory for firmware and application.
• 200 bytes of EEPROM space for data storage.
• Three LEDs:
• Green and red main status LEDs;
• Yellow Ethernet link LED.
• Power: 12VDC nominal (min. 9V, max. 18V).
• Dimensions: 90x48x25mm.
• Operating temperature range: -5 ~ 70 C.
• Firmware is upgradeable through the serial port or network (including cold upgrade firmware uploads through the network).
• CE- and FCC-certified.
• Included Accessories:
• DIN rail mounting plate
• Wall mounting plate and two screws
